Tech Support :: Dial-Up and Email Set-up :: Manual Email Set-Up :: Outlook (Office) :: 2000

Open Outlook and click Tools

* Click on Accounts to view the list of email accounts

* You will now see a list of all email accounts Outlook has been configured for
* Make sure the NetNet account is highlighted (in blue as shown) and then click Properties
* If you do not have NetNet account setup, then click Add to make a new NetNet email account

* Type your name as you would like it to appear on the email you send
* Please make sure that you have filled in your email address correctly. Substitute the word "username" as shown below for your unique NetNet username. (you will have chosen this when opening your NetNet account)
* Next you will need to check the server settings, click on the tab marked Servers highlighted above

* Set your options as above
* The server settings for checking NetNet mail should be filled in exactly as above.
* Your username should be filled in using lower case letters. Your password will be shown as *'s for security reasons. If you have to retype your password every time you check mail and you wish for Outlook to remember it for you, click in the Remember password box as shown above.
* Next you will need to check the connection options. Click on Connection as highlighted above.

* Your connection screen should look like the one above. Choose Connect using my modem and then choose the connection you have made for NetNet in Use the following Dial-Up Networking connection.
* Please click on Advanced to see the correct default settings which should not be changed

* This is what your Advanced settings should ALWAYS look like. If these are changed you might not be able to send and/or receive mail.
* Click on OK to finish.